VINCENT SA-T8 Manuel D'utilisation page 25

1 3
1. INPUT: Input Selector
This dial allows you to choose one of the six
inputs. The LED that is actually lit shows you what
input channel has been selected. Additionally
these LEDs show that the appliance is switched
on.
2. VOLUME: Volume dial
This is the knob for the adjustment of the main
volume level of the system. The LED in this dial is
blinking for some seconds while after switching
on the tubes are being warmed up or while the
preamplifier is muted.
FRONT VIEW
4
3. SR: sensor diode for the remote control
4. POWER
This is the main power switch for turning on and
off the device. The preamplifier is separated from
the mains voltage when switched off and cannot
be set into a standby state.
5. MUTE
Press this button to mute your system's loudspeakers
as an effect of muting the signals of the preamplifier
output "OUTPUT" (8) and the recording output
"REC OUTPUT" (7). After pressing this button again
the original volume level is being restored.
5 2
Vincent
25