EINHELL NEW GENERATION NVK 1601 Mode D'emploi page 15

Anleitung NVK 1601_SPK1:Anleitung NVK 1400 D
28. Always make sure that you have a solid footing
while working with the scarifier.
29. Operate the machine at a walking pace only.
30. Be particularly careful when you change direction
on a slope.
31. Be particularly careful when you turn the scarifier
around or pull it toward yourself.
32. Stop the scarifier whenever it has to be lifted for
transporting over areas other than lawns and
whenever it has to be moved from or to the area
you want to scarify.
33. Carefully actuate the starter switch in accordance
with the manufacturerʼs instructions. Make sure
your feet are far enough away from the spike
drum.
34. Never lift or carry the scarifier with the motor
running.
35. Switch off the motor and pull out the mains plug
before you leave the scarifier.
36. Allow the motor to cool down before you put the
machine in a closed room.
37. Switch the scarifier off and disconnect the power
cable before performing any adjustment or
cleaning work to the scarifier, and before check-
ng to see if the mains connection is entwinded or
damaged.
38. Socket couplers to connection elements must be
made from rubber, soft PVC or other thermo-
plastic material of equal rigidity or coated with
such material.
39. When scarifying, ensure that you avoid paths that
could restrict the free movement of the extension
cable.
40. Switch off the motor:
- before you try to remove any obstructions or
blockages,
- before performing any cleaning, checking or
adjustment work to the scarifier,
- after running over an obstruction,
- if the equipment vibrates abnormally.
41. If the machine should start to vibrate unusually, it
must be checked immediately.
42. To prevent risk of fire, keep the motor free of
grass, leaves and moss at all times.
43. For safety reasons you should always replace
worn or damaged parts.
44. If the connecting line for the machine is
damaged, it must be replaced by the manufac-
turer or its after-sales service or similarly
trained personnel to avoid danger.
45. Safety equipment must not be removed or
bypassed.
46. Make regular checks on the grass collecting
device for wear or damaged parts.
24.09.2007 13:23 Uhr
47. Wear hearing and eye protection while operating
the machine.
48. Do not connect a damaged cable to the power
supply and do not touch the cable before it is
disconnected from the power supply. A damaged
cable may result in contact with active parts.
49. Do not touch the teeth before the equipment is
disconnected from the power supply and
the teeth have reached a complete standstill.
50. Keep the cables away from the teeth. The teeth
may cause damage to the cables and result in
contact with active parts.
2. Layout and items supplied
(see Fig. 1+2)
1. ON/OFF switch
1a. Safety lock-off
2. Push bar
3. Connector plug
4. Stress-relief clip
5. Star grips
6. Operating lever
7. Ejector flap
8. Scarifying depth
9. Grass basket
3. Description of the warning logos
(see Fig. 16)
A = Important!
Read the directions for use before operating the
tool.
B = Keep other persons (and animals) away from
the danger zone.
C = Wear hearing and eye protection.
D = Sharp work tools - Do not cut your fingers or
toes! Switch off the device and pull the power
plug before engaging in any maintenance/
cleaning work or if the cable is tangled or
damaged. Keep the power cable away from the
cutting unit.
E = Keep the power cable away from the roller.
4. Proper operation
Power supply
The scarifier can be connected to any light socket
(with 230 volts of alternating current). However, the
socket outlet must have an earthing contact
protected by a 16 A circuit breaker. Additionally, a
residual current device (RCD) circuit-breaker with
max. 30 mA must be used!
Seite 15
GB
15