Publicité
Les langues disponibles
Les langues disponibles
12. The device contains hot and/or glowing and sparking components. Do not, therefore,
use where fuels, paint, flammable fluids and/or gases are stored. Do not use the
device in an environment that poses a fire risk, e.g. near gas tanks, gas pipes or
aerosols. This is an explosion and fire risk!
Warnings – use
1.
Do not use additions/accessories on the device that have not been supplied or
approved by the manufacturer.
2.
Only use the device for its intended purpose and in the manner set out in this
instruction leaflet.
3.
Some parts of this device will get very hot and could cause burns. You must pay
particular attention to children, vulnerable persons and pets that are present near
the device. Never leave them alone with a working device.
4.
Never cover or block the device; it will overheat and this could lead to a fire risk.
Never hang or place objects such as clothing, blankets, cushions, paper, etc. on the
device. The minimum distance of 1 metre between the device and flammable
materials must always be applied. Ventilation openings should never be blocked as
this may pose a fire risk. Never use the device to dry clothing or place anything on it.
Do not let anything lean against the device!
5.
Do not set the device to come on automatically using a timer, clock or other facility.
You must always check for safe conditions before using the fireplace! Never use the
device with an external voltage regulator such as a dimmer or similar, as this could be
dangerous!
6.
The device is exclusively intended for normal, household usage. Only use for
providing heat in your home.
7.
Connection voltage and frequency, as given on the device, must correspond to that of
the socket to be used and the electrical installation must be equipped with an earth
leakage circuit breaker of 30 mA . The electrical socket that you are using must be to
hand at all times in order to be able to remove the plug from the socket in the event
of an emergency.
8.
To avoid overloading and/or fuses being blown, do not use any other equipment on
the same socket or electrical group as the one used for the device.
9.
Unroll the electric cable for the device fully before inserting the plug into the socket
and ensure that the electrical cable does not come into contact with the fireplace or
get hot. Do not run the electrical cable under carpet, cover with mats, runners or
similar and do not place in areas that are walked on frequently. Ensure that it cannot
be stepped on and that no furniture is placed on top of it. Do not bend the electrical
cable around sharp corners and do not roll up too tightly after use! Prevent the
electrical cable coming into contact with oil, solvents and sharp objects. Check the
cable and plug regularly for damage. Do not bend or pinch the electrical cable and do
not wind it around the device; this could damage the insulation!
10. The use of an extension cable is not advised as this can lead to overheating and fire. If
the use of an extension cable is unavoidable, make sure that it is not damaged and
that it is an approved extension cable with a minimum diameter of 2x2,5 mm²and a
22
Publicité
