30 | English
(45)
Spindle lock
(46)
Hex socket screw for mounting the saw blade
(47)
Clamping flange
(48)
Laser beam outlet aperture
(49)
Inner clamping flange
(50)
SDS bolt
(51)
Locking screw for the adjustable fence
(52)
Threaded rod
(53)
Locking screw for length stop
(54)
Clamping screw for length gauge
(55)
Screws for insert plate
Technical data
Sliding mitre saw
Article number
Rated power input
No-load speed
Starting current limitation
Laser type
Laser class
Divergence of laser line
Weight according to EPTA-Proced-
ure 01:2014
Protection class
Dimensions of suitable saw blades
Saw blade diameter
Base blade thickness
Max. cutting width
Hole diameter
Permissible workpiece dimensions (see "Permissible workpiece dimensions", page 35)
The specifications apply to a rated voltage [U] of 230 V. These specifications may vary at different voltages and in country-specific models.
Noise Information
Noise emission values determined according to
EN 62841-3-9.
Typically, the A-weighted noise level of the power tool is:
Sound pressure level 98 dB(A); sound power level
108 dB(A). Uncertainty K = 3 dB.
Wear hearing protection!
The noise emission value given in these instructions has
been measured in accordance with a standardised measur-
ing procedure and may be used to compare power tools. It
may also be used for a preliminary estimation of noise emis-
sions.
The noise emission value given represents the main applica-
tions of the power tool. However, if the power tool is used
for other applications, with different application tools or is
poorly maintained, the noise emission value may differ. This
1 609 92A 7NA | (26.04.2022)
(56)
(57)
(58)
(59)
(60)
(61)
(62)
(63)
a)
(64)
a)
a) Accessories shown or described are not included with the
product as standard. You can find the complete selection of
accessories in our accessories range.
W
-1
min
nm
mW
mrad (full angle)
kg
mm
mm
mm
mm
may significantly increase noise emissions over the total
working period.
To estimate noise emissions accurately, the times when the
tool is switched off, or when it is running but not actually be-
ing used, should also be taken into account. This may signi-
ficantly reduce noise emissions over the total working
period.
Assembly
Avoid starting the power tool unintentionally. The
u
mains plug must not be connected to the power supply
during assembly or when carrying out any kind of
work on the power tool.
Set screw for laser positioning (parallelism)
Screw for bevel angle indicator
Stop screw for 0° bevel angle
Stop screw for left-hand bevel angle range
Stop screw for right-hand bevel angle range
Set screws for mitre angle scale
Screw for mitre angle indicator
Hook-and-loop strap
Laser lens cover
GCM 8 SDE
3 601 M19 2..
1600
3500–5300
●
650
< 0.39
1M
1.0
18.9
/ II
216
1.3–1.8
3.3
30
GCM 8 SDE
3 601 M19 2B.
1400
3500–5300
●
650
< 0.39
1M
1.0
18.9
/ II
216
1.3–1.8
3.3
25.4
Bosch Power Tools