Publicité
Les langues disponibles
Les langues disponibles
i) If the battery is damaged and leaks, avoid contact with skin and eyes. If contact happens, immediately
seek medical advice.
IV. GETTING STARTED
4.1- Unpacking
- Remove all items from carton.
- Check items for any shipping damage.
4.2- Assembly
The sprayer does not require specific assembly from the user.
Before use and at regular intervals, make sure that the tightening elements (e.g. screws, bolts, cotter pin, etc.) are
correctly installed and firmly tightened.
Important : Insert the fuse into the fuse port (16).
4.3- Battery
- Read carefully the battery safety instructions.
- Do not use other batteries than those provided with the product.
- Do not use another charger than the one provided with the product.
- Recharge battery before first use.
4.3.1- Charging the battery
- The battery must be charged for [see Characteristics table] before first use.
- This sprayer uses a high capacity 12V battery, which will provide several hours of intermittent use when
fully charged; with intermittent use defined as one minute on, one minute off.
- For maximum life this battery requires a low amperage charge rate. A fully depleted battery will take a
minimum of [see Characteristics table] hours to fully recharge.
- Always charge battery for approximately [see Characteristics table] before each use to prevent battery
from reaching a low state.
- Insert the charger plug into the charging jack inlet of the sprayer (as shown in Fig.5)
- Plug the charger into a wall socket 220-240V.
- When fully charged, remove the charger from the wall socket, then remove the charging jack.
- Once battery is fully charged, the sprayer is ready for use.
4.4- Filling the tank
- Always place the sprayer on a flat, level, bare ground when filling.
- Remove the cap.
- Use of the inlet strainer (Fig.3) is a must.
It must be in place at all times when using the sprayer.
The inlet strainer protects the pump from ingesting debris, which may cause the pump to operate poorly or
not at all.
- It is best to fill your sprayer from the side or from the front so as to avoid spillage.
- When filling the tank, the level indication marks on the tank of your sprayer should be considered
approximate as the volume of the tank can vary in the moulding process.
- Fill in the tank by pouring solution slowly to avoid any spillage (Fig.4).
- Always wipe the exterior of your sprayer if any spillage occurred while filling.
Publicité
