Publicité
Les langues disponibles
Les langues disponibles
7
Positioning and Mounting the Remote Control
● Remote control installation position
Install the remote control to a position where
the user can reach and operate it.
Install the remote control in the area shown as "Suggested installation area"
in the figure below, and ensure to install the remote control on a position
where it can be operated easily while the user is seated on the SpaLet seat.
900 (35-7/16)
600 (23-5/8)
1. Installing the Batteries and Confirming the Remote Control Installation Position
1. Open the back cover of the remote control, and
install the included batteries (AAA x 2).
* Use a tool such as a flat-blade screwdriver to push the
hook (lock) to remove the cover.
2. Confirm the remote control installation position.
2. Mounting the Remote Control
1. Remove the holder from the remote control.
2. Install the holder to the installation
position using an appropriate method
for the wall.
[See Note 7-2]
* Out of 4 slots, use the outer 2 slots (with A marks).
If the holder can be
installed only with a
hole pitch at 100 mm
(3-15/16 " ), use the inner
2 slots.
[For a plywood wall (> 5 mm (3/16 " ) thick)]
Affix the holder firmly with the supplied wood screws.
[For a plywood wall (<5 mm (3/16 " )
thick) or a plaster board wall]
① Make the pilot holes with 6 mm (1/4 " ) diameter.
(5 mm [3/16 " ]
diameter for a
plaster board wall)
② Use a hammer to
insert the supplied
plastic anchors gently.
③ A ffix the holder
firmly with the
wood screws.
Suggested installation area
Suggested installation area
for easier operation
Unit: mm
(")
Installation Procedure
[See Note 7-1]
Holder
Wood
screws
Φ 6 mm
(1/4")
Plastic
anchors
Holder
Wood screws
● Sit on the SpaLet seat and ensure the
installation position. [See Note 7-1]
Temporarily install the remote control to the target position,
and sit on the seat unit and press the [STOP] button
(ensure to perform a test operation after installation).
Then, stand in front of the SpaLet bowl and
push the [STOP] button to ensure that a
beep sound is generated from the seat unit.
• Do not push the [REAR or
[FRONT WASHING] button:
water would come out from the
seat unit.
• Ensure that there is enough space above the remote
control installation position to allow easy removal and
mount of the remote control.
Back cover
Batteries
The wood screws are tight at the beginning,
and then loosened once and tightened again.
[For a concrete wall]
① Make the pilot
holes with 6 mm
(1/4 " ) diameter
and approx. 33 mm
(1-5/16 " ) depth.
② U se a hammer to
insert the supplied
plastic anchors
gently.
③ Affix the holder
firmly with the
wood screws.
3. Align the remote
control to the
holder, and push
downward to
mount the remote
control.
4. Press the [Hr] and
[Min] buttons to set
the current time.
* Pay attention to
AM and PM.
-12 EN-
Hook (lock)
Remote control
33 mm
(1-5/16")
Plastic anchors
Φ 6 mm
(1/4")
Holder
Wood screws
Remote
Control
Holder
Time setting switch
Hr
Min
Publicité
