Technical Data; Rating Plate - Progress PAS6001E Notice D'utilisation

12 Progress
Problem
and a number come on.
You can hear a constant
beep noise.
comes on.
If you cannot find a solution...
If you cannot find a solution to the problem
yourself, contact your dealer or an
Authorised Service Centre. Give the data
from the rating plate. Give also three digit
letter code for the glass ceramic (it is in
the corner of the glass surface) and an

TECHNICAL DATA

Rating plate

Model PAS6001E
Typ 60 HAD 54 AO
Ser.Nr. .................
PROGRESS
Cooking zones specification
Cooking zone
Left front
Left rear
Possible cause
There is an error in the hob.
The electrical connection is
incorrect.
The second phase of the
power supply is missing.
Nominal Power (Max heat set‐
ting) [W]
2300
1200
Remedy
Deactivate the hob and acti‐
vate it again after 30 sec‐
onds. If
disconnect the hob from the
electrical supply. After 30
seconds, connect the hob
again. If the problem contin‐
ues, speak to an Authorised
Service Centre.
Disconnect the hob from the
electrical supply. Ask a
qualified electrician to check
the installation.
Check if the hob is correctly
connected to the electrical
supply. Remove the fuse,
wait one minute, and insert
the fuse again.
error message that comes on. Make sure,
you operated the hob correctly. If not the
servicing by a service technician or dealer
will not be free of charge, also during the
warranty period. The instructions about
the Service Centre and conditions of
guarantee are in the guarantee booklet.
PNC 949 492 376 01
220 - 240 V / 400 V 2N 50 - 60 Hz
Made in Romania
6.5 kW
Cooking zone diameter [mm]
210
145
comes on again,