Operation - Laserworld RTI ATTO RGB 1.7 Mode D'emploi

Manual: RTI ATTO Series

8. Operation

1. Power
Make sure that your device is provided with the correct voltage. Wrong voltage could
lead to irreparable damages. Please find the correct voltage data in the synoptical table
at the end of this manual. It must be ensured that the device is not directed to people
or inflammable objects during installation. The "Power" diode on the rear side of the
device begins to light up after the device has been connected to power and the
key has been switched ‚ON'.
2. ILDA in / ILDA through
The device can be controlled via ILDA control signal. There are a ILDA-in (ILDA input)
and a ILDA-through (ILDA loop through) interface on the rear side of the device. Con-
nect the laser system to the control interface (DAC) by using an ILDA cable. Do not con-
nect the laser to standard parallel port at your computer, but always use an appropriate
ILDA interface (usually is sold together with the laser control software). After that you
are able to control your laser by a showlaser software (e.g. Phoenix or Pangolin). Use the
ILDA-through interface to daisy-chain the signals (from ILDA-in) to a further device.
3. X/Y Axis
There are four trim pots for X and Y axis adjustments on the rear side of the unit. Use the
X-Axis pots to vary or to glean the picture along the x-axis. Use the Y-Axis pots to vary or
to glean the picture along the Y-axis. Avoid that both pots are set to centerposition at the
same time. Otherwise the power density of the beam gets extremly high! (You can avoid
this by activating the safety with beam block.)
4. Fuse
There is a fuse at the rear side of the device. If the fuse should blow, please change it by
a new 2.5At. If the problems recurs, please contact your dealer or the Laserworld service
department.
5. Colors
The trim pots Red, Green and Blue on the rear side of the device can be used to adjust the
single colors in their color balance.
Red: Turn the „Red"- pot to adjust the red color balance.
Green: Turn the „Green"- pot to adjust the green color balance.
Blue: Turn the „Blue"- pot to adjust the blue color balance.
6. Interlock
There is an Interlock interface on the rear side of the device. Please connect the Interlock
dongle with the interface. The laser device only runs when the dongle is inserted.
page 7 / 27