Preparation - Eurosystems SC 42 Mode D'emploi

DESCRIPTION OF CONTROLS (fig. 1)
n
1) Accelerator level 2) Fitting insertion level 3) Tool transfer raising lever) Handle for the job depth adjustment 5) Engine 6) Grass bag (optional)
7) Handles 8) CE Decal 9) Safety device.

PREPARATION

n
During working wear ear protectors, sturdy footwear and long trousers should be worn . Do not work when barefoot or wearing open sandals.
Please wear protective goggles when using the machine without grass catcher.
Check the area on which the scarifier is to be used carefully and remove any stones, sticks, wire, bones or other foreign objects which could be thrown
by the blades causing damages to the unit.
Before using the unit please always check the coupling of nuts, screws, bolts and check the cutting set not to be worn out or damaged.
Change the full set of the damaged or worn blades in order to keep the tool balancing.
WARNING !! The petrol/gasoline is highly inflammable
- Store fuel only in containers intended for this purpose.
- Fill tank outdoors and do not smoke during this process; keep away from other heat sources.
- Put in the fuel before starting the engine.
- Never remove cap from fuel tank or add oil whilst the engine is running or the unit is hot.
- If fuel has overflowed, do not attempt to start the engine. Move the scarifier away from the area polluted with fuel. Do not attempt to start until the
fuel fumes have evaporated.
- For safety reasons, replace the fuel tank and tank cap if damaged.
- Use an appropriate funnel or filler tube when refuelling to prevent fuel from spilling on the engine, the housing or grass.
- For tank filling in operations use a proper funnel or filling tube in order to avoid the petrol/fuel coming out on the engine , casing or grass.
- after filling operations , safely re-position the tank caps and the fuel container ones.
The exhaust and area around it may heat up to 80° C; the temperature of some parts of the guard grids can exceed 110°C. WARNING: Risk of burning.
Replace any damaged exhaust pipes.
Instructions for use
n
Never run the internal combustion engine in enclosed areas in which dangerous fumes may collect - danger of inhalation of poisonous fumes!
Use the unit only in daylight or with good lighting. While there are no regulations governing operating times, consideration should be shown to others
living nearby and to local rules, if any.
Do not use the scarifier on very steep slopes. Be particularly careful when changing the direction of travel on slopes.
Disengage blade rotation when the machine is being pushed over non-grass surfaces. Danger of stones being sucked up by the machine or being
expelled.
Never operate the scarifier with the damaged housing/casing or defective or missing protective devices (e. g. protection deflector, back opening
etc.).
The engine adjustment has been correctly set at the factory and should not be altered. Carefully start the engine according to manufacturer's
instructions.
Never tip the scarifier whilst starting the engine. If the machine has to be lifted, it must be tilted only as strictly needed and max 5 cm. Do not bend
7