Image Load; Image Processing; Colour Settings; Measurement Of Circumference, Area And Volume - MS Multiscan Mode D'emploi

5.3.2 Image Load

Press M/0 in the mode of real time or freeze to display image process menu. Then press
ZOOM/1 ，the following will appear：
Input the number of stored image according to the message, for example 01. Press NOTE
after input, then No. 01 image is picked out.（If it is the wrong input, press CLS to clean the
characters one by one and re-input）.01/128 is displayed in the lower left-hand corner on
the screen. 01 is the number of current image and 128 stands for the storage capacity. At this
time, press▲3 or ▼6 to pick out images in other storage areas.
Press FREEZE to return to real-time state. To pick out other images, repeat the above
procedure.

5.3.3 Image processing

Press M/0 in real-time state to display the menu of image process, and then press +/2 to
select image processing. Repeat this to modify the smoothness and the image is displayed in
the upper right-hand corner of the screen in real-time state. They are respectively：IM0. IM1.
IM2. IM3.
Normal

5.4 Colour settings

Press M/0 in real-time state to display the menu of image process, and press ▲3 to lighten
colour on the right side. Use 5 or 4 to select modify items and press▲3 and ▼6 to adjust
the parameters.
IC0. IC1. IC2. IC3 are image coded colour, representing respectively grey, red, yellow and blue.
CC0. CC1 are colour of characters, representing grey and yellow.
BC0. BC1 are background colour, representing grey and blue.

5.5 Measurement of circumference, area and volume

Two methods are available.
●PressM/0 in the state of freeze, the menu is displayed on the screen.
● Press 4 to select 4.AREA-VOLM, and it is displayed as follow：
The first one is freehand method and the second is Ellipse method.
PLEASE ENTER STORAGE NO.:
Smoothed
PLEASE ENTER:
1.FREEHAND 2.ELLIPSE
43