Charging The Battery Pack - MS Multiscan Mode D'emploi

The MS Muliscan has a holder to safely secure the probe. To attach, press the probe
against the holder until it snaps into place. To detach, push the probe upwards and
take it out (See figure 3-1)
 Install/Detaching the battery pack from the display unit:
Remove the battery cover by sliding the release catch, and then take out the battery
pack (See figure 3-2)

3.4 Charging the Battery Pack

There are two ways to charge the battery pack
(1 ) Charging via Display Unit
Make sure that the battery pack is in the display unit. Connect the power cord of the "Input"
port in the AC-adaptor to the power outlet, and then connect the power cord of the "Output
DC14V/3A" port in the AC-adaptor to the "DC 14V" jack in the display unit. The "Charge"
indicator (right beside the powerlight) on the front panel will light up and charging will begin.
When charging is complete, indicator light will go out.
(2) Charging via AC-Adaptor (optional)
Detach the battery pack from the display unit. Connect one end of the power cord to the
"Charge DC 12.6V/1A" port on the AC-adaptor, and the other end to the "golden connector"
on the battery pack. The "Charge" indicator on the AC-adaptor will light up and charging will
begin.
Caution
Do not use the "Output DC14V/3A" port and the "Charge DC12.6V/1A" port
on the AC-adaptor at the same time.
36
Figure 3-2. install/Detaching the Battery Pack
Battery release key