Image Process; Image Storage - MS Multiscan Mode D'emploi

Press ZOOM/1 to confirm. During the process, "ERASING..." will appear in the upper left-hand
corner and at the same time, other operations are unavailable. When it disappears, the
storage is erased. Press +/2 to abandon and exit.
Attention:
Before the erasing is completed,( when"ERASING..." exists），other
operations are not allowed, they could damage the device.
● Press BB/8 and select "8.DEFAULT SET" to restore the factory settings.
● Press BM/9 and select "9.BEEP-ON" to switch on or switch off the beeping.
Note：When0.NAME. 3.COMMENT. 5.HOSP are input， no number input is available. In
note menu, press NOTE to exit directly.

5.3 Image Process

Press M/0 in freeze state, the following menu enters the display . There are functions to save,
load, image processing, change colour of the back ground and letters and to measure an
area, volume and histogram.

5.3.1 Image Storage

128 images can be stored permanently, also when the power is turned off for a longer period
of time.
●Press M/0 to display image process menu after a satisfactoring image is frozen, to store the
image press M/0, the stored images automatically receive a number this number displayed in
the upper left corner when the image is stored, example "SAVING......05". When the storage is
completed, the number disappears. Press FREEZE to return to real-time state.
When the memory is full(reaches 128 stored items), the following message will appear：
If is the message states to erase No. 01；Press ZOOM/1 to replace；Press +/2 to abandon
the storage of the current image.
Notes：
●If the Memory for storage is full, and you want to store another item. A message will
appear that an item should be erased in order to store the new image.
42
V1.20
0.SAVE
1.SVLOAD
2.IMAGEPROC
3.COLOR
4.AREA-VOLM
5.HISTOGRAM
V1.20: Software version number
STORAGE IS FULL. ERASE NO.01
1.YES 2.NO
？