Table des Matières
Publicité
D D épannage
Dépannage
Problème
Cause possible
L'outil ne démarre pas
La clé de démarrage de sécurité n'est pas insér-
ée.
Le produit est en panne de carburant.
L'interrupteur ON/OFF (marche/arrêt) est à la
position OFF (Arrêt).
L'étrangleur est à la position OFF (Arrêt, fermé). Déplacer l'étrangleur à la position ON
L'amorceur n'est pas enfoncé.
Le moteur est noyé.
Le fil de la bougie d'allumage n'est pas con-
necté.
La bougie d'allumage est défectueuse.
Il y a de l'eau dans le carburant ou le carburant
est trop vieux.
Il y a de la vapeur dans la conduite de carbur-
ant.
Autres causes.
Le commutateur de carburant (selon l'équipe-
ment) est à la position CLOSE (arrêt).
La commande d'accélération est à la position
STOP (Arrêt).
56
Solution
Insérer la clé de de démarrage de
sécurité.
Remplir le réservoir de carburant
avec de l'essence fraîche et propre.
Placer l'interrupteur ON/OFF (mar-
che/arrêt) à la position ON (marche).
(Marche, complètement ouvert).
Appuyer sur l'amorceur.
Attendre quelques minutes avant de
redémarrer, NE PAS purger.
Redémarrer le moteur à plein régime
avec l'étrangleur à la position OFF
(Arrêt, fermé).
Connecter le fil à la bougie d'allu-
mage.
Remplacer la bougie d'allumage
Vider le réservoir de carburant et le
carburateur. Remplir le réservoir de
carburant avec de l'essence fraîche
et propre.
S'assurer que toute la conduite d'ali-
mentation en carburant est en des-
sous de la sortie du réservoir de car-
burant. La conduite d'alimentation en
carburant doit fonctionner en perma-
nence entre le réservoir de carburant
et le carburateur.
Lire attentivement les méthodes de
démarrage de ce manuel.
Placer le commutateur de démarrage
du moteur à la position ON (marche).
Déplacer la commande d'accéléra-
teur à la position FAST (Rapide).
621 - 005 - 31.05.2018
housing or chute deflector, and when making any
repairs, adjustments or inspections.
•
When cleaning, repairing or inspecting the product,
stop the engine and make certain the augers and all
moving parts have stopped. Disconnect the spark
plug wire and keep the wire away from the plug to
prevent someone from accidentally starting the
engine.
•
Do not run the engine indoors, except when starting
the engine and for transporting the product in or out
of the building. Open the outside doors; exhaust
fumes are dangerous.
•
Exercise extreme caution when operating on slopes.
•
Never operate the product without proper guards,
and other safety protective devices in place and
working.
•
Never direct the chute deflector toward people or
areas where property damage can occur. Keep
children and others away.
•
Do not overload the product capacity by attempting
to clear snow at too fast a rate.
•
Never operate the product at high transport speeds
on slippery surfaces. Look behind and use care
when operating in reverse.
•
Disengage power to the augers when the product is
transported or not in use.
•
Use only attachments and accessories approved by
the manufacturer of the product (such as wheel
weights, counterweights, or cabs).
•
Never operate the product without good visibility or
light. Always be sure of your footing, and keep a firm
hold on the handles. Walk; never run.
•
Never touch a hot engine or muffler.
W W ork area safety
•
Thoroughly inspect the area where the equipment is
to be used and remove all doormats, sleds, boards,
wires, and other foreign objects.
•
Disengage all clutches and shift into neutral before
starting the engine (motor).
•
Do not operate the product without wearing
adequate winter garments. Avoid loose fitting
clothing that can get caught in moving parts. Wear
footwear that will improve footing on slippery
surfaces.
•
Handle fuel with care; it is highly flammable.
•
Use an approved fuel container.
•
Never add fuel to a running engine or hot engine.
•
Fill fuel tank outdoors with extreme care. Never
fill fuel tank indoors.
•
Never fill containers inside a vehicle or on a truck
or trailer bed with a plastic liner. Always place
containers on the ground, away from your
vehicle, before filling.
•
When practical, remove gas-powered equipment
from the truck or trailer and refuel it on the
ground. If this is not possible, then refuel such
621 - 005 - 31.05.2018
equipment on a trailer with a portable container,
rather than from a gasoline dispenser nozzle.
•
Keep the nozzle in contact with the rim of the fuel
tank or container opening at all times, until
refueling is complete. Do not use a nozzle lock-
open device.
•
Replace gasoline cap securely and wipe up
spilled fuel.
•
If fuel is spilled on clothing, change clothing
immediately.
•
Use extension cords and receptacles as specified by
the manufacturer for all units with electric drive
motors or electric starting motors.
•
Adjust the auger housing height to clear gravel or
crushed rock surface.
•
Never attempt to make any adjustments while the
engine (motor) is running (except when specifically
recommended by the manufacturer).
•
Always wear safety glasses or eye shields during
operation or while performing an adjustment or
repair to protect eyes from foreign objects that may
be thrown from the machine.
Personal protective equipment
Always use the correct personal protective equipment
when you operate the product. This includes, at
minimum, sturdy footwear, eye protection and hearing
protection. Personal protective equipment does not
erase the risk of injury but may decrease the grade of
injury if an accident occurs.
•
Always wear safety glasses or eye protection while
you operate the product or do maintenance or
repairs.
•
Always wear appropriate winter garments when you
operate the product.
•
Always use heavy-duty slip-resistant boots with good
ankle support while you operate the product.
•
Do not wear loose fitting clothing that can get caught
in moving parts.
•
Use approved protective gloves, if necessary. For
example, when attaching, examining or cleaning the
blade.
•
Always use approved ear protection while you
operate the product. Noise for a long period can
cause noise-induced hearing loss.
Safety devices on the product
•
Make sure that you regularly do the maintenance to
the product.
•
The life of the product increases.
•
The risk of accidents decreases.
Let an approved dealer or an approved service
center regularly examine the product to do
adjustments or repairs.
•
Do not use a product with damaged protective
equipment. If the product is damaged, speak to an
approved service center.
5
Publicité
Table des Matières
