Studer C-S Serie Manuel D'utilisation Et De Montage page 10

STUDER Innotec
2.3.3 Serial and parallel connection
3 Mounting and installing
3.1 Installation place
The location of the COMPACT must be driven by the following criteria:
− Protection from unauthorized handling
− Dry dust free room, no condensation
− Never install directly over the battery and never in a cabinet together with the
batteries
− Keep ventilation holes free
− In mobile installations it is important to keep the vibrations down as low as
possible
3.2 Fixing
3.2.1 Fixing the COMPACT
Basically the COMPACT can be installed in any
desired location. Preferred is that the appliance be
wall mounted with battery cables downwards. The
COMPACT must be fixed directlyon the a flat, non
flammable surface, with four screws through the four
holes (diameter 5.5mm) which are accessible from
the outside. In motor vehicles, the COMPACT must
be fixed on a flat plate itself fixed on vibrations
reducing elements. The COMPACT must not be
fixed on a combustible base, as the back of the
casing can get hot and reach up to 80 degree
Celsius.
3.2.2 Protection cover IP-23
This cover IP23 (Order ref. CIP-23) can be easily
installed after the fixation of the COMPACT. For
that release a little the too screws down and more
the tow up. Then it's possible to pass the IP 23
cover between the COMPACT and the wall. The
cover must touch the screws. Lock on the four
screws, it's ready.
COMPACT V6.4
COMPACT
10/85