Energetics CT 421pa Manuel D'assemblage page 10

10
What does the POLAR® logo mean?
Problem
No resistance.
No speed signal.
The upright post shakes.
The home fitness equipment shakes.
The home fitness equipment creates
abnormal noises.
ENERGETICS products that carry this logo can be used with a uncoded
chest belt.
Solution
Manual controlled products:
1. Check if the plug of the resistance cable is correctly connected,
see chapter 'assembly'.
2. Check lower resistance cable which is connected to the break system.
Power magnetic (motor) controlled products:
1. Check if power cable is plugged-in.
2. Check the computer cable connection.
3. Check motor power connection.
4. Replace the motor.
Electromagnetic controlled products:
1. Check if power cable is plugged-in.
2. Check the computer cable connection.
3. Check the inner power cable to the break system and electronic board.
4. Replace the flywheel or electronic board.
1. Check the upper cable connections.
2. Check if the speed sensor is in the right position.
3. Replace the speed sensor.
4. Replace the computer.
1. Loose upright post screws.
2. Re-insert screws/washers and tighten screws equally.
1. Use the rear stabilizer height adjustment to level out any une-
venness.
2. Move the equipment to a different place and check if the prob-
lem still persists.
1. Check the fit of the stabilizer bolts.
2. Check the end caps.
3. Check whether the pedals are assembled correctly or not, see
chapter 'assembly'.
4. Check crank arms, turning discs, cross frames, axis, and bearings
(if applicable).