Publicité
Les langues disponibles
Les langues disponibles
•
Then fasten the blade guard (A) with 4 bolts (L) in the
holder (N).
H
J
K
•
Fit the drive disc (B) on the output shaft.
•
Turn the blade shaft until one of the holes in the drive
disc aligns with the corresponding hole in the gear
housing.
•
Insert the locking pin (C) in the hole to lock the shaft.
•
Place the blade (D) and support flange (F) on the
output shaft.
G
F
B
C
•
Fit the nut (G). The nut must be tightened to a torque
of 35-50 Nm (3.5-5 kpm). Use the socket spanner in
the tool kit. Hold the shaft of the spanner as close to
the blade guard as possible. To tighten the nut, turn
the spanner in the opposite direction to the direction of
rotation (Caution! left-hand thread).
When loosening and tightening the saw blade nut, there is
a risk of injury from the teeth of the saw blade. You should
therefore always ensure that your hand is shielded by the
blade guard when doing this. Always use a socket
spanner with a shaft that is long enough to allow this. The
arrow in the diagram shows the area where you should
56 – English
R
L
A
D
ASSEMBLY
operate the socket spanner when loosening or tightening
the nut.
Fitting the shredder blade and the
shredder blade guard (355FRM)
•
Fit the holder (K) and bracket (J) with 4 bolts (H) on the
gear housing.
H
J
K
•
Then fasten the shredder blade guard (A) with 4 bolts
in the holder as shown.
A
x 4
Publicité
