Sicce Syncra SDC 6.0 Manuel D'instructions page 14

SPECIAL MAINTENANCE AND REPLACING GROUP ROTOR
Follow this instruction for an accurate rotor kit cleaning or replacing
Repeat the opening actions as indicate in Maintenance' section,
steps 1,2,3,4.
10
To easily remove the bottom bearing, we suggest to leave the pump
submersed with water and Pump Clean for a while to make soften
debris or limestone.
- Insert the hook ( accessory) inside the tube of the pump. (Pic 10)
- Hook the bearing and pull it out
-Clean the bearing under running water (never use soap or detergent
RIGHT SIDE
of any kind because they pollute the aquarium water: we recommend
using a vinegar and water solution) possibly using a soft brush to
2
remove scale deposits. If it is heavily worn we suggest to replaces it
1
with a new one.
-Re-insert the bearing sleeve in the pump ( Pic.10) after wetting and
push it all the way.
SYNCRA SDC · 6.0 · 7.0 · 9.0 INSTRUCTION MANUAL · EN
INDEX