Sicce Syncra SDC 6.0 Manuel D'instructions page 15

CONTROLLER USE AND PUMPS REGULATION
By connecting the power supply to the controller, all the LEDs light
up once. After about 20 seconds the Wi-Fi symbol will start to flash
slowly to indicate that it is ready and awaiting the set-up. After the
configuration, once connected to the Wi-Fi network, the led will make
5 rapid flashes every 5 seconds. If the controller has already been
set-up, once powered, the Wi-Fi automatically reconnects to the
network and reloads the programs set in the CONTRALL App.
To activate the pump, keep the right key (+) pressed for 3 seconds.
The pump starts at 50% of the operating range. Pressing the keys
(+) and ( -) it is possible to increase or decrease the pump flow.
Consequently, the luminous intensity of the 5 LEDs will vary. The
pump symbol will light up in the color set via the CONTRALL App.
The Wi-Fi symbol will flash blue slowly while waiting to be connected
to the Wi-Fi network via the CONTRALL App. If the pump is managed
via CONTRALL, it will not be possible to modify its operation using the
controller. It will only be possible to switch it off by keeping the right
key (+) pressed for 3 seconds.
The Controller supplied can only regulate the flow. It can only be
powered with the included transformer and manages only the
supplied pump. Any other use could irreparably damage the device
and void the warranty.
SYNCRA SDC · 6.0 · 7.0 · 9.0
NEW SDC SMART CONTROLLER
SPEED LED
CUSTOM COLOR
PUMP'S ID
WI-FI
SPEED DOWN
SPEED UP /
ON - OFF
INDEX
INSTRUCTION MANUAL · EN