Napoleon Element NEFB42H-BS Manuel D'installation Et D'opération page 27

symptom
Ember bed is Brightness not selected.
not glowing or
Ember LED issue.
dimming.
Main PCB board issue.
LED fl ashing Appliance has overheated
"OH". and safety thermal switch has
tripped.
problem
See "operation" section.
Inspect the ember bed LEDs and replace, if necessary.
Inspect the main PCB board and replace, if necessary.
Unplug power or turn off the circuit breaker. Allow appliance
to cool for 15 minutes, then plug in the appliance or turn the
breaker on. If problem persists, consults your dealer.
troubleshooting
solution
W415-4035 / 03.23.22
EN
27