3.4
appliance installation and fi nishing
1. Remove the front decorative cover held in place by 2 magnets (Fig. 3-1).
2. With one hand on the glass door to prevent it from falling, remove the 2 screws holding the glass door in place
(Fig. 3-2).
Decorative
Cover
3. Carefully lift the glass door out of the 2 slots in the bottom of the fi rebox (Fig. 3-3). Set the glass door on a
soft, non-abrasive surface.
4. Complete hard-wiring (see "electrical information" section).
note:
It is recommended to complete fi nishing of the wall before fully securing the appliance (Fig. 3-4, next page).
installation and fi nishing
Fig. 3-1
Slot
W415-4035 / 03.23.22
EN
Fig. 3-2
Fig. 3-3
11