Publicité
Les langues disponibles
Les langues disponibles
DRAWER
1.
Pull drawer out as far as possible from housing.
Slide black levers on drawer's side rails and pull
the drawer completely out from housing.
NOTE: Drawer may be easier to assemble
with table upside down.
2. Secure front mounting plate to drawer housing using
two 1/4 x 3/4" hex head bolts and 1/4" flat washers.
(See Figure 13)
NOTE: Leave bolts on front mounting plate loose.
NOTE: Front of drawer should sit 3/4" back of
front edge of front rail.
3. Insert two 1/4-20 x 3/4" hex head bolts through holes
in rear of drawer housing. Attach drawer to strut
using two 1/4" strut nuts. (See Figure 13)
4. Tighten previously installed hex head bolts in
front mounting plate. Slide drawer into housing.
(See Figure 13)
Figure 13
Front Mounting Plate
Front Rail
1/4" Flat Washer
Hex Head Bolt
Front of Drawer Housing
PAGE 6 OF 24
ASSEMBLY CONTINUED
1/4 x 3/4"
VERTICAL UPRIGHTS
1.
Place 1/4" flat washer onto 1/4 x 2¾" hex head bolt.
Insert bolt through rear frame extension. Repeat for
remaining bolt. (See Figure 14)
2. Thread one 1/4" strut nut onto each previously
installed 1/4 x 2¾" hex head bolts. Turn
approximately two threads. (See Figure 14)
3. Hold vertical uprights against the back of the rear
frame extension. Insert strut nuts into uprights, and
turn clockwise to secure nut inside of upright.
Tighten hex head bolts. (See Figure 14)
Figure 14
End Cap
1/4" Flat Washer
Strut
Hex Head Bolt
Strut Nut
4. Repeat steps 1-3 for remaining upright.
NOTE: 12" of the upright must be located below
the bench top for stability and safety.
1/4" Strut Nut
1/4 x 2¾"
0523 IH-10871
Publicité
