Uline H-10871 Mode D'emploi page 4

8. Mount feet to base legs using four 5/16-18 x 3"
hex head bolts and 5/16" washers. (See Figure 6)
9. Mount cross brace between feet using four
5/16-18 x 3" hex head bolts, 5/16" washers
and locknuts. (See Figure 6)
Figure 6
Locknut
10. Tighten all nuts and bolts.
11. Loop and tuck excess hydraulic line into
cross channel in middle of frame. (See Figure 7)
12. Install glides and end caps. (See Figure 7)
Figure 7
PAGE 4 OF 24
ASSEMBLY CONTINUED
Cross Channel
13. Lay frame and leg assembly upside down onto
bench top with back of frame flush with back
of bench top.
IMPORTANT! Bench top should overhang front
of frame by 1¼" on front and 2½" on sides.
14. Drill holes in bench top 1/2" deep with #28 drill bit.
Secure frame to bench top with eleven #12 3/4"
pan head screws into drilled holes. (See Figure 8)
Figure 8
0523 IH-10871