Publicité
Les langues disponibles
Les langues disponibles
WIRING BENCH TOP
1.
Drill 3/8" hole three inches from back of bench top
and five inches from side of bench top. (See Figure 9)
Figure 9
Back of Bench
2. Install the following hardware into the previously drilled
hole on the bench top in the order listed below.
(See Figure 10)
Above bench top: Serrated washer (A),
large ring terminal (B), 5/16 x 2" hex head bolt (C)
Below bench top: 5/16" flat washer (D),
ground cord (E), 5/16" flat washer (F), yellow insulated
ring terminal (G), 5/16" flat washer (H), 5/16" nut (I)
Figure 10
C
B
A
Bench Top
D
E
F
G
H
I
3. Tighten 5/16" nut.
PAGE 5 OF 24
ASSEMBLY CONTINUED
4. If not already drilled, measure approximately eight
Figure 11
3"
5"
5. Secure pre-wired jacks into front rail with two
6. Run wires from pre-wired jacks along underside of
7.
8. Use self-adhesive pads and cable ties to secure cables
Figure 12
inches in from outside of leg and one inch down
from top of bench top. Drill front rail with 5/16" drill bit.
(See Figure 11)
5/16" thin hex nuts. (See Figure 12)
bench top. Cut wire to appropriate length, leaving
approximately 1-2" of slack. (See Figure 12)
Strip ends of jack wires 1/4" and connect to the
yellow insulated ring terminal on underside of table.
Crimp the ring terminal to secure.
to table. (See Figure 12)
Self-Adhesive Pads
IMPORTANT! When assembly is complete,
connect remaining ring terminal to ground
cord (E) on underside of bench top to the
center of a grounded outlet. (See Figure 10)
1"
8"
0523 IH-10871
Publicité
