Kortel Design Kuik III Notice D'utilisation page 48

Preparing your harness
Accessories
Cocoon mounting:
The cocoon has been designed specifically to fit your Kuik III.
The adaptation on the harness has been thought out to be as
simple as possible, while keeping a perfect design and finish. If
necessary, the footrest must be removed.
The assembly is done by carrying out the following steps:
- Connect the Dyneema loops to the anchor points.
- Connect the zipper under the harness.
- Connect the side plastic clips on both sides.
- Fit the lower straps for adjusting the cocoon into the metal
hooks at the front of the frame's thighs
- Pass the cocoon's elastic loop over the left thigh strap.
- Connect the anti-slip closure system to the frontal strap.
- Pass the closing clip located on the harness through the
dedicated opening in the cocoon.
1
1.1 1.2
1
2
3
4
5
6
7
1.1
1.2
3
2
7
The length of the cocoon can be adjusted using these hooks.
Once the correct length has been determined, the buckle can
be locked by mus the strap through the hook.
(See "Installing the footrest").
48
KUIK III
1
5
5
4
4
6