Dreame H11 Max Manuel D'utilisation page 15

How to Use
EN
Start Cleaning
The vacuum is equipped with an upright/tilt switch. Please use it at an angle after
turning it on.
Short press the to power on and the vacuum starts cleaning. Press again to stop
working.
Note: When the vacuum is working, do not lift it up and down or move it, and do not
tilt the vacuum to one side or lay it flat to protect against the dirty water back into the
vacuum.
＜140° ＜40°
Do not recline the vacuum more than 140° to protect against water leakage.
Auto Mode/Water Absorption Mode
The vacuum is powered on by default in Auto mode, you can switch to the Water
Absorption mode according to actual needs.
Auto Mode: The vacuum will adjust the suction power according to the stains on the
ground.
Water Absorption Mode: If there is water on the ground, the water absorption mode can
be selected to clean it up.
11