Publicité
Les langues disponibles
Les langues disponibles
maintenance
extractor hood
Clean the grease filters as soon as the grease filter indicator
light comes on.
The stainless steel on the outside of the hood can be
cleaned with soapy water and a damp cloth. The stainless
steel will regain its shine if you occasionally use a stainless
steel care product or polish. The polish imparts a dirt-
resistant layer to the stainless steel. Always clean the
stainless steel in the direction of polishing.
Never use abrasive cleaning agents (such as green scouring
pads or other scourers) or polishing cleaning products (such
as liquid scourers).
Never use caustic cleaning agents. These can cause
stainless steel to discolour.
changing the light bulbs
Pull the light bulb (B) down a little and loosen connector (A).
Press the spring (C) in a little and loosen the light bulb (D)
from the casing (E).
Put in a new light bulb with the same wattage and fit it in the
opposite order.
E
GB 8
maintenance
(continued)
removing/replacing grease filters
Remove the filters as follows: switch the fan and the lighting
off. Take hold of the grease filter by the handle and pull it
down from the lock.
The filter can only be put back into place in one way. Take
note of the correct position of the filter (see illustration).
Hold the filter in such a way that the handle is at the back of
the hood.
Put the filter back into place by first pushing the front side
into the hood. Tilt the rear side up and click the filter into the
lock. The filter is now once again in place. Erase the
electronic memory by pressing the
5 seconds.
cleaning the grease filters
You can clean the grease filters in the dishwasher. Allow the
filter to drain well - through the slits in the side - before
putting it back.
button for approx.
OFF
GB 9
Publicité
