Publicité
Les langues disponibles
Les langues disponibles
switch off the key signal
OFF
As you press a key, a key signal sounds in confirmation.
Press keys
the in order to switch on the key signal.
Repeat this procedure if you wish to switch off the key
signal again.
GB 6
ON
12h
en
for 3 seconds continuously on
ON
12h
faults
Please check the following points which may solve the problem, before calling the service
department.
If the connection cable is damaged, it should be replaced by the service department of the
manufacturer or similarly qualified persons in order to prevent dangerous situations from arising.
N N B B : : Disconnect the appliance from the mains before starting any repairs, preferably by removing
the plug from the socket or by setting the isolation switch to zero.
fault
cause
Lighting does not work.
Lamp defective.
Extractor hood makes a lot of
Discharge duct too long or has
noise.
too many bends.
Motor defective.
No extraction.
Motor or controls defective.
Connection lead defective.
solution
Change the light bulb (see
page 8 "Changing the light
bulbs").
NB:
Only use the same type of lamp
with the wattage stated.
Change the discharge duct
(see installation instructions).
Phone the Service department.
Phone the Service department.
Phone the Service department.
GB 7
Publicité
