Publicité
Les langues disponibles
Les langues disponibles
PREPARE THE CABINET
The cabinet must be secured to wall studs or other
wooden framework behind the drywall to support
the weight of this unit . Failure to do so may cause
personal injury or damage to countertop or cooktop .
NOTES: A . The unit has to be installed inside the cabinet . If
installing with one of the optional liners (PM400SS
unit only), use it as a template to cut the hole in
the bottom of the cabinet .
B . The unit should be mounted centered laterally
over the cooktop burners .
C . For back to front position, the unit must be
mounted according to local building codes .
1 . Cut a hole in the bottom of the cabinet, using the
dimensions shown (FIG . 7), or use the optional liner as a
template (PM400SS unit only) .
2 . PM400SS unit only: Where needed, install the metal liner .
3 . Measure the remaining material of the cabinet bottom sides
(C), (FIG . 8) if it is 1/4" or more, there is no need to use
the cabinet brackets . Go to step 8 on page 10 .
4 . When there is less than 1/4" remaining material (C),
carefully remove those strips . Measure the cabinet inner
width (D) (FIG . 8) . Refer to the table below to see which
cabinet bracket edge configuration must be used .
u
nit
PM400SS
BBN2243SS
BBN2303SS
5 . Pay attention to the Ease of Install hooks location on the
unit (distance given from unit front flange, FIG . 9) . Measure
and mark the position of the Ease of Install hooks (shown
as E in FIG . 10 on next page) on both cabinet side walls .
8
WARNING
!
n
W
arroW eDge
D
From 19-9/16"
From 20"
to < 20"
to 20-1/2"
D
From 22-1/16"
From 22-1/2"
to < 22-1/2"
D
From 28-1/16"
From 28-1/2"
to < 28-1/2"
iDe eDge
D
D
to 23"
D
to 29"
8¼"
HD1387A
CUT A HOLE IN THE BOTTOM OF THE CABINET
A = 10¼" (all units)
HD1381
B = 19
/
" (PM400SS)
9
16
B = 22 ¹/
" (BBN2243SS)
16
B = 28 ¹/
" (BBN2303SS)
16
HD1382
UNIT TOP VIEW
FRONT
FIG. 7
FIG. 8
4½"
FIG. 9
Publicité
