Publicité
Les langues disponibles
Les langues disponibles
OPTIONAL LINERS
(PM400SS UNIT ONLY)
For installations where the PM400SS unit is less than 30"
above cooktop, this powerpack insert should be mounted into
a metal liner (FIG . 2) to protect cabinetry combustible material
from heat, in order to meet building code requirements . This will
allow easier cleaning and provide protection to the cabinetry .
Refer to table at right to find the liner model corresponding to
the cabinet style and width .
Visit www .broan-nutone .com or www .broan-nutone .ca to view
specific model information .
NOTE: Since this manual covers different unit models, some
details in the following illustrations may slightly differ
from your unit .
REMOVE THE ADAPTER/DAMPER
Detach and set aside the 3¼" x 10" adapter/damper (grey part
in FIG . 3) from the side of the powerpack insert by removing
its 2 retaining screws . Discard the screws .
REMOVE THE CABINET BRACKETS
Detach the cabinet brackets (grey part in FIG . 4) from the back
of the powerpack insert by removing its 4 retaining screws .
Discard the screws .
Fold up and down the bracket until it is split in two separate
parts (FIG . 5) . Keep the brackets for possible further use .
NOTE: Both cabinet brackets have one wide edge and one
narrow edge (FIG . 6), to cover all installation
configurations depending on cabinet widths .
METAL LINER
HD1051
l
c
iner MoDel
LB30SS
LB36SS
SCREWS
HD1372
SCREWS
HD1369
HO0413
Narrow edge
Wide edge
HO0408
FIG. 2
abinet noMinal WiDtH
30"
36"
FIG. 3
FIG. 4
FIG. 5
FIG. 6
7
Publicité
