Publicité
Les langues disponibles
Les langues disponibles
INSTALL THE UNIT (
h
orizontal exhauSt inStallation only
6 . Reinstall and secure the faceplate on the unit by securing
the faceplate to the unit using its 4 retaining screws (two
per side, circled in FIG . 28) . Plug the blower cable to its
connector on faceplate (FIG . 28) .
CONNECT DUCTWORK
v
ertical exhauSt inStallation only
Ducted Installation
Use 6-in . round or 3¼" x 10" metal duct to connect the
adapter damper on the top of the unit to the ductwork
above (FIG . 29) . Seal the joint using aluminum duct tape .
Non-Ducted Installation
A non-duct kit is required for this type of installation
(purchase separately) . To install, follow the instructions
packed with the kit . Refer to table below to find the
appropriate non-duct kit according to the unit .
Unit model
PM400SS
BBN2243SS
BBN2303SS
'
)
cont
d
(
'
)
cont
d
Non-Duct kit model
HARKPM21
HARKBN24
HARKBN30
HD1425
HJ0256
FIG. 28
FIG. 29
15
Publicité
