Midi Transmit Switch Setup (Tx-Sw); Transmitting Midi Data In Bulk (Bulk-Tx) - Sony DPS-V77 Mode D'emploi

MIDI Transmit Switch Setup (Tx–Sw)
Tx-Sw lets you control how MIDI exclusive data is output from
this unit (except when using Bulk-Tx).
1 Press SYSTEM.
2 Press FUNCTION D to choose "MIDI."
3 Press FUNCTION D to choose "Tx–Sw."
FUNCTION A [PANEL] selects the whether or not exclusive
messages that appear when buttons on the front panel are
pressed will be sent via MIDI OUT.
Transmitting MIDI Data in Bulk (Bulk–Tx)
Bulk–Tx lets you transmit MIDI data in bulk.
1 Press SYSTEM.
2 Press FUNCTION D to choose "MIDI."
3 Press FUNCTION E to choose "Bulk–Tx."
FUNCTION A [Type] selects the type of data that will be
transmitted (U1, U2, U1+U2, SYSTEM, or ALL).
FUNCTION B [NUM] selects whether to transmit all the
contents of a memory bank, or only individual memory
numbers (when you select U1 or U2 for the [Type]).
FUNCTION F [EXEC] to sends the data.
Note
Be sure that both the sending and receiving MIDI channels are set
to the same values. If the sending and receiving channels are
different, the data will not be received even if OMNI is set to ON.
27
EN