Bus Mode Installation; Introduction; Terminal Wiring; Dip Switch Settings - RISCO Group Watch OUT Guide D'installation

Introduction

The information in this section relates to WatchOUT DT installation in BUS Mode only. Up to 32
BUS detectors can be installed on the ProSYS RS485 BUS, saving cabling time and enabling
remote control and diagnostics.

Terminal Wiring

+,-
Used for the connection of 12VDC power supply. Connect the (+) terminal to
the AUX RED and the (–) terminal to the COM BLK of the ProSYS terminals
YELLOW
Used for data communication with the ProSYS. Connect to the terminal to the
BUS YEL of the ProSYS
GREEN
Used for data communication with the ProSYS. Connect to the terminal to the
BUS GRN of the ProSYS
TAMPER
Used for the wiring for tamper detection, see below
LED
Used for the wiring for tamper detection, see below
ENABLE
Note:
All terminals that are not mentioned in the table above are unused.
Cover and Back Tamper
BUS Mode:
Cover + Back tamper wiring
ProSYS
Short
AUX COM
BUS
RED BLK
YEL GRN
TAMPER FREE
FREE
+ - ALARM
YEL GREEN

DIP Switch Settings

DIP Switch Description
Number
1 - 5 Used to set the detector ID number. Set the ID number in the same way as for
any other ProSYS accessory (Refer to the ProSYS installation instruction
manual)
6 - 8 Not used

BUS Mode Installation

BACK
TAMPER (N.C)
AM LEDs
SET/
DUST TEST
UNSET
ENABLE
Cover Tamper to Zone Input
Zone
ProSYS
Input
BUS
Zone
AUX COM
BUS
Z1 COM
RED BLK
YEL GRN
TAMPER
FREE
+ ALARM
-
YEL GREEN
WatchOUT DT Installation Manual
Cover Tamper Only
ProSYS
Cover Tamper Wiring
AUX COM
BUS
Short
RED BLK
YEL GRN
TAMPER
FREE
+ - ALARM
YEL
BUS Mode:
Cover Tamper to Zone Input
Z2
Short
FREE AM LEDs
SET/
DUST TEST
UNSET
ENABLE
BUS Mode:
FREE AM LEDs
SET/
DUST TEST
UNSET
GREEN ENABLE
13