Publicité
Les langues disponibles
Les langues disponibles
6.5
Attachment and replacement of Velcrobacked abrasive discs (H)
Caution! Hazard due to running machine! There is a risk due to unintended start-
up of the GECKO STAR machine when replacing the sanding disc. Be sure to unplug th
e mains connector before replacing the sanding disc.
Caution! Risk of cutting injuries to the hands!
The grinding grains on the sanding discs have sharp edges. Wear protective gloves whe
n changing the sanding discs.
Caution!
The sanding disc must lie centrally on the sanding plate. Ensure that there is an even
margin around the edge of the sanding disc.
Steps:
1
Switch the machine off.
2
Unplug the mains plug.
3
Lay the machine down on its side. 4
Take the used sanding disc (1) off the sanding plate (2). 5 Place a new Velcro-
backed sanding disc centrally on the sanding plate
and press the sanding disc on.
Use following sanding discs: (I)
6.6
Attachment and replacement of abrasive discs that are fastened on with the pap
er holding plate. (J)
Caution! Hazard due to running machine! There is a risk due to unintended start-
up of the GECKO STAR machine when replacing the
sanding disc. Be sure to unplug the mains connector before replacing the sanding disc.
Caution! Risk of cutting injuries to the hands!
The grinding grains on the sanding discs have sharp edges. Wear protective gloves when
changing the sanding discs.
Steps:
1
Switch the machine off.
2
Unplug the mains plug.
3
Lay the machine down on its side.
4
Hold the sanding disc (3) firmly in place.
5
Unscrew the paper holding plate (2) with the twopin spanner (1).
Remove the worn sanding disc.
6
Place the new sanding disc on and fasten this with the paper holding plate.
Tighten the paper holding plate down with the twopin spanner (1).
Publicité
