VOLTCRAFT VC-13 Mode D'emploi page 40

All manuals and user guides at all-guides.com
DC Symbol for direct current
v volt (unit of electric voltage)
Ω, kΩ, MΩ Ohm (unit of electrical resistance), Kilo-Ohm (exp.3), Mega-Ohm (exp.6)
NCv Measuring function of the contact-free mains voltage recognition
Symbol for the LED lamp function
Button for switching on and off
8. MEaSurINg
Do not exceed the maximum permitted input values. Do not touch any circuits
or parts of circuits if they may be subject to voltages higher than 33 V/aCrms
or 70 V/DC! Danger to life!
Before measuring, check the connected measuring lines for damage such as,
for example, cuts, cracks or squeezing. Defective measuring lines must no
longer be used! Danger to life!
During measuring, do not grip beyond the tangible grip range markings
present on the measuring prods.
Measurements in electrical circuits >33 V/aC and >70 V/DC must only be car-
ried out by specialists and technically instructed personnel who are familiar
with the relevant regulations and the ensuing risks.
Ensure before each measurement that the hold button "h" has not been
pushed at the beginning of the measurement (display with the hold button
pushed: "h"). If the hold button is pushed at commencement of measuring,
no measured value is displayed!
observe the required safety notes, provisions and safety measures for
intrinsic protection.
33