Publicité
Les langues disponibles
Les langues disponibles
en-us
Operating the appliance
Individual parts of the burner
Ensure that the individual parts of the burner are fitted in
the correct position and are straight; otherwise, this may
result in ignition problems or problems during operation.
Ensure that the burner head and burner ring fit so that
the locking catches on the bottom of the burner snap into
the appropriate recesses. The direction of burner head
and burner ring doesn't matter.
Note: If the burner parts are fitted at an angle, the
appliance will not work.
Individual parts of the standard-output burner and
high-output burner
(
Burner cap
0
Burner ring
8
Burner head
@
Ignition plug
H
Thermocouple
14
Operating the appliance
O p e r a t i n g t h e a p p l i a n c e
N otes
Only use the accessories specified. Do not line the
▯
stainless steel recess (e.g. with aluminum foil).
The burner and ignition plug must be clean and dry.
▯
Only light the burners if the pan supports and all
▯
burner parts are correctly fitted.
When one burner is ignited, an ignition spark will also
▯
be generated at all the other burners.
Do not touch the ignition plug while the gas appliance
▯
is being lit.
It is important to keep the appliance clean. If the
▯
ignition plugs are dirty, this may cause ignition
problems. Clean the ignition plugs regularly with a
small, non-metallic brush. Take care to prevent the
ignition plugs from suffering any heavy knocks.
When you switch from setting 3 to setting 4 or higher,
▯
the burner will briefly switch to its maximum output.
This is to optimize ignition between the burner rings.
Do not cover the ventilation openings on the rear of
▯
the gas cooktop.
When the gas cooktop is switched on, the electronics
▯
open up the gas supply, which produces a short
sound. This is normal.
In the event of a power failure, the appliance will not
▯
work. The gas supply is shut off.
Publicité
