Publicité
Les langues disponibles
Les langues disponibles
Before
Using Your Refrigerator
It is important to prepare your refrigerator for use. This section tells you how to clean it, connect it to a power
source, install it, and level it.
Cleaning
your refrigerator
Removing
packaging
materials
Remove tape and any inside labels (except the model
and serial number label) before using the refrigerator.
To remove any remaining
tape or label glue:
l
Rub briskly with thumb.
OR
l
Apply liquid hand-dishwashing
detergent to area
before removing glue as described above. Do not use
sharp instruments,
rubbing alcohol, flammable fluids,
or abrasive cleaners. These can damage the material.
See "Important Safety Instructions"
on page 3.
NOTE: Do not remove any permanent instruction
labels inside your refrigerator. Do not remove the Tech
Sheet fastened under the refrigerator at the front.
Cleaning
it before
use
After removing all packaging materials, clean your refrig-
erator before using it, if necessary. See
cleaning instructions on page 18.
Plugging
it in
Fire Hazard
Do not use an extension
cord.
Doing so can result in death, fire, or electrical
shock.
Recommended
Grounding
Method
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused and
properly grounded electrical supply is required. It is
recommended
that a separate circuit serving only this
appliance be provided. Use a receptacle which cannot
be turned off with a switch or pull chain. Do not use an
extension cord. See Electrical Requirements
and
Grounding
Instructions
Sheet in your Literature
Package.
Electrical
Shock Hazard
Plug into a grounded
three prong outlet.
Do not remove ground
prong.
Do not use an adapter.
Failure to follow these instructions
can cause
death, fire, or electrical
shock.
Sprang
grounding
type wall receptacle
Refrigerator
power cord
Sprang
grounding
plug
-
Publicité
