JohnBean B 300 Manuel D'utilisation page 38

1
D
W
O
1
38
5-11
2 3
5-12
5-13
Operation
5.6 Data detection mode
5.6.1 Manual Mode
5.6.1.1 Width Manual Entry
• Manual measurement with gauge for steel rims
(Figure 5-11) or data acquisition from the rim.
• From the control panel, select the width (W). The last
entered value is displayed.
• To edit the value, press keys + / - (1, 2, Figure 5-12).
• Type in Enter by selecting key 3 (Figure 5-12).
5.6.1.2 Distance Manual Entry
• Correctly position measuring arm 1 (Figure 5-13) and
read the value from the scale on the measuring
armrod.
• From the control panel, select the distance (O). The
last entered value is displayed.
• To edit the value, press keys + / - (1, 2, Figure 5-12).
• Type in Enter by selecting key 3 (Figure 5-12).
5.6.1.3 Diameter Manual Entry
• Acquire rim nominal diameter by reading the value
on the rim or on the tyre.
• From the control panel, select the diameter (D). The
last entered value is displayed.
• To edit the value, press keys + / - (1, 2, Figure 5-12).
• Type in Enter by selecting key 3 (Figure 5-12).
...