Publicité
1
22
4-7
3
2
4
5
4-8
4-9
4-10
Layout
4.3
Stop brake
Fig. 4-7 Pedal of wheel stop brake
Activate the pedal to brake the wheel holder chuck
and make fi xing nut clamping or unclamping easier.
The wheel is also retained in the correct position to
allow for an easier weight application.
Warning:
This stop brake is designed only to facilitate
orientation of the wheel and must not be used for
braking the chuck during operation.
Note:
On wheel balancers "p" equipped with the quick-
clamping Power Clamp device, the pedal also
controls the Power Clamp, for clamping the wheel
on the unit.
• Lift the pedal so as to clamp or unclamp the wheel.
• Press the pedal to engage the brake and stop the
chuck.
4.4
Measuring Gauge
Fig. 4-8 Measuring Gauge to measure distance and
diameter
1
Gauge, it can be extracted and extended
upwards
2
Stick-on weight holder jaw to measure the
application position and to fi x the compensation
weight
3
Stick-on weight fi tted
4
Gauge head to identify rim dimensions on a
variety of rim profi les.
5
Spring-loaded applicator pushing the weight.
4.5
Ultrasonic detector
On the outer side of the machine there is an ultrasonic
detector for measuring the wheel width (Fig. 4-9).
The sonar has a tolerance of +/- 0.5''.
Such tolerance does not jeopardise the accuracy of
the balancing procedure.
4.6
Laser Pointer
Figure 4.-10
The machine uses the Laser Pointer to indicate the
precise point for the application of the stick-on weights
F
on the rim (
5.8.2).
...
Publicité
