Publicité
112
Trouble shooting
H90
Wheel acceleration was too slow, or braking was too
weak after a measuring run. If the main shaft does
not reach the required rpm, check whether the brake
was activated or whether the mass of the wheel is too
great. In this case:
Release the brake.
Make sure that the shaft with the wheel clamped on it
can rotate freely.
Turn the wheel by hand, then run the START.
If the error cannot be eliminated, call the service team.
H91
Rpm variation during measuring run. The brake may
be ON.
Release the brake.
Make sure that the shaft with the wheel clamped on it
can rotate freely.
Repeat the run.
7.2
7.2
After-sales service
After-sales service
Contact your area agent.
Contact your area agent.
The company website provides information about the
Customer Assistance service around the world:
The company website provides information about the
Customer Assistance service around the world:
http://www.johnbean.com
http://www.johnbean.ca
http://sbs.snapon.com/support
Customer Care
Hotline (International) +49 8634 622-8996
Phone: 800-362-4618
or: 800-362-4608·
http://www.snapon-equipment.eu
Hotline (German): +49 8634 622-8994
Reception +49 8634 622-0
· Snap-on Equipment Germany ·
· Konrad-Zuse-Straße,1 D-84579 Unterneukirchen ·
...
Publicité
