PeakTech 1565 Mode D'emploi page 51

9.5. Remote Control Mode (P 1570 / 1580)
There are two methods for remote control of current and voltage adjustment. Both methods
require current remote control part to be set up in order for remote control mode to be
functional, otherwise unit will be in CC mode all the time.
Method A:
Using two external variable DC voltage sources.
PIN
1
2
3
4
5
6
7
8
Check the output voltage range of the power supply by varying the external voltage source.
Short circuit the main output with 8AWG (8,35mm
varying the external voltage source.
Method B:
Using two 0-5K Ohm variable resistors
Remark: variable resistors 5KOhm
PIN
1
2
3
4
5
6
7
8
Check the output voltage range of the power supply by adjusting the 5Kohm variable resistor.
Short circuit the main output with 8AWG (8,35mm
adjusting the variable resistor.
Funktionen
Internal DC +5V
Voltage Adjust
Current Adjust
Ground
Output OFF
N.A.
N.A.
N.A.
2
) wire to check the display for CC setting
Function
Internal DC +5V
Voltage Adjust
Current Adjust
Ground
Output OFF
N.A.
N.A.
N.A.
2
) wire to check the display for CC setting by
51
Beschreibung
Less than 50mA
0 ~ 5 V
0 ~5 V
Short to Ground
Remarks
Resistor end
Variable part of resistor
Variable part of resistor
Another resistor end
Short to Ground