PeakTech 1565 Mode D'emploi page 50

Method A:
Using Voltage Source
A variable external voltage source of 0 – 5 V is fed into the remote control terminal to adjust
the output voltage level.
Warning:
Do not input higher than 5 V, otherwise it may damage the unit.
1. Make sure the load is disconnected and the power supply is OFF.
2. Use Only wires from port 3 and 4. Then, connect port 3 to positive polarity of the external
voltage source and port 4 to negative polarity of the external voltage source.
3. Use a 8AWG (8,35mm
4. Switch on the power supply.
5. Vary the external input voltage 0 – 5 V to check and verify for the full output current range
of power supply.
6. Switch off the power supply and disconnect the 8AWG (8,35mm
Method B:
Using 5 kΩ Variable Resistor
1. Make sure the load is disconnected and the power supply is OFF.
2. Prepare a 5 kΩ variable resistor and use wires from port 1, 3 and 4.
3. Use a 8AWG (8,35mm
4. Switch on the power supply.
5. Adjust the 5 kΩ variable resistor from one end to other end to check and verify for the full
output current range of power supply.
6. Switch off the power supply and disconnect the 8AWG (8,35mm
2
) wire to short circuit the main output terminal in the rear panel.
PIN 3
2
) wire to short circuit the main output terminal in the rear panel.3.
50
2
) wire.
2
) wire.