Safety Precautions - PeakTech 1565 Mode D'emploi

1. Safety Precautions

This product complies with the requirements of the following directives of the European Union
for CE conformity: 2014/30/EU (electromagnetic compatibility), 2014/35/EU (low voltage),
2011/65/EU (RoHS).
We herewith confirm that this product meets the essential protection standards, which are
given in directions of council for adaptation of the administration regulations for UK of
Electromagentic Compatibility Regulations 2016 and the Electrical Equipment (safety)
regulations 2016.
To ensure safe operation of the equipment and eliminate the danger of serious injury due to
short-circuits (arcing), the following safety precautions must be observed.
Damages resulting from failure to observe these safety precautions are exempt from any legal
claims whatever.

Read these operating instructions carefully and make them available to subsequent users
as well.

It is essential to observe the warning notices on the device, do not cover or remove them.

Familiarize yourself with the functions of the device and its accessories before using it for
the first time.

Do not operate the device unsupervised or only protected against unauthorized access.

Use the device only for the purpose of its intended use and pay particular attention to the
warning notices on the device and information on the maximum input and output values.

Before connecting the device to a socket, check that the voltage setting on the device
corresponds to the existing mains voltage

Only connect the device to sockets with an earthed neutral conductor.

Do not place the device on a damp or wet surface.

It is essential to keep the ventilation slots in the housing free (if the cover is covered,
there is a risk of heat build-up inside the device).

Do not insert any metal objects through the ventilation slots.

Do not place any liquids on the device (risk of short circuit if it tips over).

Never use the device if it is not completely closed.

Replace defective fuses only with a fuse that corresponds to the original value.

Never short-circuit the fuse or fuse holder.

Check the device and accessories for possible damage or bare or kinked cables and
wires before commissioning. If in doubt, do not take any measurements.

It is essential to observe the warning notices on the device.

Do not expose the device to extreme temperatures, direct sunlight, extreme humidity or
moisture.

Avoid strong vibrations.

Do not operate the device near strong magnetic fields (motors, transformers, etc.).

Clean the housing regularly with a damp cloth and a mild cleaning agent. Do not use any
corrosive abrasives.

This device is only suitable for indoor use only.

Avoid any proximity to explosive and flammable substances.

Opening the device and maintenance and repair work may only be carried out by
qualified service technicians.

Never short-circuit the remote sensor connections

Do not make any technical changes to the device.
35