PeakTech 1565 Mode D'emploi page 44

7. Using the power supply
1. This series has 4 models. Make sure you have used the correct one. They have different
output voltage range and current as following:
Model Number
®
PeakTech 1565
®
PeakTech 1570
®
PeakTech 1575
®
PeakTech 1580
®
PeakTech 1585
2. Make sure that the correct model is selected before operation.
3. Make sure the Mode Switch is at Normal Position.
4. The power supply will perform a series of self checks when it is switched on. The LED
and other indicators on the front panel will be on by turn. When the cooling fan is being
checked, a high speed wind noise can be heard. After the self checks, the CV, V and A
LED indicators are lit up displaying voltage and 0.0 current. To find out about the set CC
current level, just turn the current control knob one click in either direction. The current
display returns to 0.0 after a few seconds.
Below table to show the self test sequence
Self test display and Sequence
Output Voltage Range
1 – 16 V
1 – 32 V
1 ~ 60 V
Total Rated Current
Test contents
To show software version
Segment check
C.V. Indicator check
C.C. Indicator check
Rear control indicator check
Return to C.V.
Start to check
Over voltage protection check
Over load protection check
Over temperature protection check
Output off (remote control mode)
44
0 - 40 A
0 - 60 A
0 - 20 A
0 - 30 A
0 - 15 A
Fan check