Service Mode - Dometic 4000 Série Manuel D'utilisation

3.2 Using the flush handle (4700 models only)
3
Flush Handle
➤ Lift the flush handle to fill the bowl to the
desired water level .
3.3 Understanding the indicator lights for 4500, 4600, 4700, and 4800
Indicator
Power on
Tank level
*Flush actuation is disabled to prevent overfilling the holding tank
3.4 Changing the flush modes for 4500, 4600, 4700, and 4800
Flush modes
Normal
Dry bowl
➤ To change modes, press the Flush switch or handle until the power-on light begins flashing
(about five seconds) .
➤ Release the Flush switch or handle .
3.5

Service Mode

To clean the toilet bowl or seals, or to perform other servicing that requires keeping the flush ball
open without running water, use the Service switch .
➤ Push and hold the Service switch for three seconds .
➤ Perform the required servicing .
➤ After servicing is complete, push and hold the Service switch for three seconds to change
back to normal operation .
5
4
➤ Press the flush handle down, then release it
Light
Steady green
Flashing green
Amber
Red
Action
Adds water to the bowl after
every flush
Does not add water to the
bowl after every flush
Flush Handle
to flush the toilet .
Electrical power to the toilet is
activated
The flush mode is changing
The holding tank is 75% full
The holding tank is 100% full*
Gallons per flush
1 quart (0 .95 liters)
1 pint (0 .5 liters)
Toilets
Status
EN