Télécharger Imprimer la page

SUHNER MACHINING BEM 12 Dossier Technique page 29

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 20
(Y) (uncushioned part of the stroke) is adjusted by moving
the cushioning cylinder. Use a caliper gage or scale gage
as an adjusting aid.
Make sure to observe safety spacing S!
F
ine Adjustment
To achieve the precise dimension X (1), loosen the screw
2) and rotate the stop pin to the precise dimension (3).
One revolution corresponds to a stroke length adjustment
of 0.5 mm. Ten markings have been applied along the
perimeter of the stop pin, i.e., 0.05 mm per marking. The
fine adjustment range amounts to 10 mm. After fine ad-
justment, tighten the screw (2).
2.4.2 A
dVAnce speed
In order for the advance speed to be adjusted the air sup-
ply lines have to be connected.
Turn regulating valve on braking cylinder to adjust the
working stroke speed. The rapid travel speed (forward
and backward) can be adjusted by means of adjustable
check valves in the pneumatic lines. Please refer to sec-
tion 2.3.3.
2.5 r
Ating dAtA
Max. drilling capacity in steel 600 N/mm
Total stroke
Trust at 6 bar
Stroke speed
Air connection inner diameter
Air consumption per cm stroke
Tool hoder: Collet chuck
Sleeve mount DIN 55058
Running trueness
Maximum speed
Working speed
50Hz 2900min
50Hz 1450min
60Hz 3500min
60Hz 1750min
Type of motor protection
Motor output rating
Motor speed rating 50Hz
System voltage
Weithg
Paint coating
2.6 O
Temperature range during operation: +20 to +50°C
Maximum relative air humidity: 90% at +30°C, 65% at
+50°C
Compressed air: 5-7bar
Compressed air for pneumatic according to DIN ISO
8573-1 [5/4/4]
ants and tool holding devices.
Use rotational and advance speeds which are assigned
to the tool and to the material.
2
Ø 12mm
80mm
1470N
10-10000mm/min
-1
0.75kW
-1
0.55kW
-1
0.9kW
-1
0.66kW
0.75kW/0.55kW/0.9kW/0.66kW
perAting cOnditiOns
Handle tools with caution; keep tools in clean and
sharp condition and observe the tool manufac-
turer's instructions with regard to the use of cool-
4mm
0.15l
ER25
ST28
0.02mm
10000min-
1
-1
70-7730min
-1
35-3870min
-1
80-9280min
-1
40-4650min
IP 55
-1
-1
2'900min
/1450min
230/400/460V, 50Hz
16kg
RAL5012
29

Publicité

loading