Panasonic SDC07 3E5 Serie Manuel D'installation page 28

17. Circulation Liquid
Set circulation of heating water.
There are 2 types of settings, water and anti-freeze function.
(CAUTION) Please set glycol when using anti-freeze function.
It may cause error if setting is wrong.
18. Heat-Cool SW
Able to switch (fi x) heating & cooling by external switch.
(Open) : Fix at Heating (Heating +DHW)
(Short) : Fix at Cooling (Cooling +DHW)
(CAUTION) This setting is disabled for model without Cooling.
(CAUTION) Does not display if there is no Optional PCB.
Timer function cannot be used. Cannot use Auto mode.
19. Force Heater
Under manual mode, user can turn on force heater through quick menu.
If selection is 'auto', force heater mode will turn automatically if pop up error
happen during operation.
Force heater will operate follow the latest mode selection, mode selection is
disable under force heater operation.
Heater source will ON during force heater mode.
3-4. Operation Setup
Heat
20. Water temp. for heating ON
Set target water temperature to operate heating operation.
Compensation curve: Target water temperature change in conjunction with
outdoor ambient temperature change.
Direct: Set direct circulation water temperature.
In 2 zone system, zone 1 and zone 2 water temperature can be set separately.
21. Outdoor temp. for heating OFF
Set outdoor temp to stop heating.
Setting range is 5°C ~ 35°C
22. T for heating ON
Set temp difference between out temp & return temp of circulating water of
Heating operation.
When temp gap is enlarged, it is energy saving but less comfort. When the
gap gets smaller, energy saving effect gets worse but it is more comfortable.
Setting range is 1°C ~ 15°C
28
Initial setting: Water
Initial setting: Disable
Initial setting: Manual
Initial setting: compensation curve
Initial setting: 24°C
Initial setting: 5°C
System setup
Demand control
SG ready
External compressor SW
Circulation liquid
Select
System setup
SG ready
External compressor SW
Circulation liquid
Heat-Cool SW
Select
System setup
External compressor SW
Circulation liquid
Heat-Cool SW
Force Heater
Select
55°C
Hot water temperature
35°C
-5°C
compensation curve
ON
24°C
Out
Return
Out — Return = 1°C ~ 15°C
17:26, Wed
Confi rm
17:26, Wed
Confi rm
17:26, Wed
Confi rm
Decide temperature
of 4 points as shown
in diagram
Outdoor
15°C
temperature
OFF