Installation - PLYMOVENT MobileGo Manuel D'installation Et D'utilisation

4

iNSTaLLaTioN

4.1 Tools and requirements
You need the following tools and requirements to install the
unit:
- basic tools
4.1.1 To be sourced locally
- plug (except for MobileGo in 230V/1ph/50Hz)
A (8x)
4.2 unpacking
B (8x)
Make sure that the product is complete. The package contains:
C
Filter unit
- mobile filter unit
- washer M6 (8)
- bolt M6x25 (8)
Extraction arm
In case of MobileGo: hose tube arm
- extraction arm (pre-assembled; excl. hose tube)
- hose tube
- hose clamp (2)
- rotating flange
- arm swivel ring, incl. rubber collar
- extraction hood
- hood collar with safety mesh
- washer M20
In case of MobileGo : metal tube arm
plus
- extraction arm (pre-assembled)
- rotating flange
- arm swivel ring, incl. rubber collar
- extraction hood
- hood collar with safety mesh
- washer M20
4.3 arm on mobile unit
To install the extraction arm, do the following.
TiP
Do a balance check of the arm before you fasten the
hoses. Refer to section 6.3.
Fig. 4.1
• Install the rotating flange (C) on the filter unit with the 8
bolts M6x25 (A) + washers M6 (B).
A (8x)
B (8x)
C
Fig. 4.1 Rotating flange
Fig. 4.2
• In case of a hose tube arm: put the hose tube over the
internal rods of the arm.
• Move the hose clamp (C) and the arm swivel ring (incl.
rubber collar) (D) over the hinge rod (B).
• Put the washer M20 (E) on the rotating flange (F).
• Put the hinge rod (B) in the rotating flange (F).
• Put the hose (A) over the arm swivel ring (D).
0000111659/150418/B MobileGo
• Use the rubber collar to make the connection airtight.
• Attach the hose (A) to the swivel ring (D) with the hose
clamp (C).
aTTENTioN!
Make sure to install the washer M20 (E) between
the rotating flange and the swivel ring to avoid
damage.
A (8x)
Fig. 4.2 Arm on mobile unit
B (8x)
4.4 Mounting of the hood
C
To install the extraction hood, do the following.
Hose tube arm (EconomyArm): refer to Fig. 4.3
Metal tube arm (KUA): refer to Fig. 4.4
• Loosen the mounting material that is attached to the hood
hinge.
• Install the extraction hood (G) with the bolt (F), 2 washers
(E), 2 spring washers (D) and a locknut (C).
• Install the hood collar (H) to the hood (G). Fasten it with
the clip.
• Install the hose tube (A) to the hood.
• Fasten the hose tube with a hose clamp (B).
A
B
Fig. 4.3 Hood mounting (hose tube arm)
A
B
C
D
E
F
F
C D (2x)
E (2x)
G
H
A
B
C
D
E
F
EN - 6