Publicité
Les langues disponibles
Les langues disponibles
oPeRAtIon
1. Plug in power cable and turn power switch on.
2. Select bill counting settings.
Add Mode
To continuously add totals for a cumulative total when counting several batches of bills, press ADD. The ADD indicator light will turn on.
Batching Mode
The machine is preset to common counting mode, which automatically counts all bills placed into the hopper. To count bills in batches,
press BATCH. Batching is preset to 100 bills. To change batch amount, press C to clear, and use the keypad to enter a batch number
between 1 and 999. Press set to save the setting.
Auto/Manual Start Modes
The machine is preset to automatically start counting bills once placed into the hopper. To change to the manual start mode, press
MNL, insert the bills into the hopper, and press RESTART.
3. Test Run
Test the machine to set it to count your currency. Prepare at least five bills to test the machine. Place the bills on the hopper and run
the machine. If the machine counts the bills and there are no errors, it is ready to accept your currency.
If: 1. The bills are deformed
2. The machine is considerably slow
3. Error message is lit frequently
The hopper tension is too tight. To loosen this tension, please turn the Bill Thickness Adjuster one notch to the right (+).
Place the bills back into the hopper to test the machine again. If errors occur, adjust as necessary.
If: 1. The bills are flying out
2. The display shows a miscount
3. Error message is lit frequently
The hopper tension is too loose. To tighten this tension, please turn the Bill Thickness Adjuster one notch to the left (-).
Place he bills back into the hopper to test the machine again. If errors occur, adjust as necessary.
When the machine is running without any errors, it is ready to accept your currency.
4. Insert bills into the hopper to begin counting.
8
Publicité
