Milwaukee 5517-20 Manuel De L'utilisateur page 5

SPECIFICATIONS
Cat. No. ..................................................... 5517-20
Type ......................................................... SDS-Max
Volts .............................................................120 AC
Amps ...................................................................14
No Load RPM ....................................................490
BPM .................................................................3310
Capacities
Twist bit ...................................................... 1-9/16"
Core bit .............................................................. 5"
Tunnel bit ..................................................... 2-5/8"
ASSEMBLY
To reduce the risk of injury, always
WARNING
unplug tool before changing or
removing accessories. Only use accessories
specifically recommended for this tool. Others
may be hazardous.
Always use a side handle when using this tool.
Always brace or hold securely.
Adjusting the Side Handle Position
1. Unplug tool.
2. Loosen the side handle by unscrewing the side
handle grip until the side handle rotates freely.
3. Rotate the side handle to the desired position.
4. Tighten the side handle grip securely.
To reduce the risk of injury, do not
WARNING
grasp the bit while the chuck is
rotating or while the bit is falling from the chuck.
Installing Bits and Chisels
Be sure that the shank of the bit is clean. Dirt particles
may cause the bit to line up improperly. Do not use
bits larger than the maximum recommended capacity
of the drill because gear damage or motor overload-
ing may result. For best performance, be sure that
the bit is properly sharpened and the shank is lightly
greased before use. Use caution when handling hot
bits and chisels.
WARNING! Do not touch the drill bits or chisels with
bare hands immediately after drilling; they may be
hot and could burn skin.
OPERATION
To reduce the risk of injury, always
WARNING
wear proper eye protection marked
to comply with ANSI Z87.1.
When working in dusty situations, wear appro-
priate respiratory protection or use an OSHA
compliant dust extraction solution.
Keep hands and cord away from the bit and all
moving parts.
Always use a side handle when using this tool.
Always brace or hold securely.
Selecting Action
MILWAUKEE Rotary Hammers
have three settings: hammering
with rotation, hammering-only,
and chisel adjustment.
1. Hammering with rotation.
Use this setting for drilling
holes with drill bits.
2. Hammering only. For use
with "hammering-only" acces-
sories. Use this setting for
chiseling or setting self-drilling
anchors.
3. Chisel adjustment. Use this
setting to adjust the angle of
the chisel blade in relation to
the tool. With a chisel mounted
in the tool:
•Turn the knob to this setting
•Rotate the chisel to the de-
sired angle
•Turn the knob to "hammering-
only".
NOTE: To engage the hammer-
ing mechanism, maintain pres-
sure on the bit. When the pres-
sure on the bit is released, the hammering will stop.
Starting and Stopping
1. To start the tool, grasp the handle(s) firmly and
pull the trigger.
2. To stop the tool, release the trigger. Make sure
the tool comes to a complete stop before laying
the tool down.
SDS-Max Drive System
1. Unplug tool.
2. Insert the bit or chisel into the nose of the tool.
3. Push bit into tool until it locks.
4. Check to see that the bit is locked by tugging on it.
5. To remove bits and chisels, pull back on the bit
release collar and remove bit.
Position the tool, grasp the handles firmly and pull
the trigger. Always hold the tool securely using both
handles to maintain control. This tool has been de-
5
Operating