EUROM Sani Wi-Fi 600 Mode D'emploi page 23

1. Make sure the device is correctly mounted.
2. Make sure the ON/OFF switch is in the OFF
position (Figure 11, pos. 2).
3. Place the power plug (Figure 11, pos. 1) into
an earthed wall socket that is easily
accessible. Use an earthed wall socket with a
minimum power of 800 Watt.
Operation
WARNING
Before every use, make sure that:
•
•
•
•
•
CAUTION
When the device is turned on or off, it may emit a sound. This is material
expanding and shrinking during heating and cool-down.
1. Set the ON/OFF switch to the ON position
(Figure 12, pos. 1).
2. The control panel and display (Figure 12,
pos. 2) will light up.
3. Press the Plus or Minus button to set the
desired temperature, from 0 °C to 37 °C.
The device starts heating when the set
temperature is higher then the ambient
temperature.
4. The display will first show the set
temperature for 3 seconds followed by the
ambient temperature.
you operate the device with dry hands;
the device is clean and dry;
the device is not damaged;
the device is not covered or blocked;
the device is securely mounted.
Figure 11
Figure 12
23